Logo

P1834 Engine Trouble Code

Meaning of P1834 engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P1834 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for P1834 code is occuring now you should check P1834 repair processes.
Now don't ask yourself; What should you do with P1834 code ?
The solution is here :

P1834 Possible Solution:

P1834 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

P1834 Code Meaning :

P 1 8 3 4
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine Fuel And Air Metering Engine Oil Temperature Sensor Malfunction Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector) Timing Reference High Resolution Signal A Too Many Pulses

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

P1834 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P1834 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Main reason For P1834 Code

The reason of P1834 OBD-II Engine Trouble Code is Engine Oil Temperature Sensor Malfunction.

P1834 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.